Aerial AD 420 사용 설명서 - 페이지 10

{카테고리_이름} Aerial AD 420에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aerial AD 420 16 페이지.

6.5 Condensate removal

The dehumidifiers AD 420 / 430 are provided with water collecting bucket

(AD 420 = 8,3 ltr / AD 430 = 12,0 ltr) and connection for hose 12 mm.

The water bucket is in the device on a balance. The balance is activated by the

weight of the full bucket and the device is switched off. Switch off the unit at the

on/off-switch and empty the bucket. After the bucket is placed in the device again,

turn on the device at the on-/off-switch.

A connection outlet 12 mm is placed above the bucket. Remove the bucket

provided that you would like to guide the condensate directly into a drain. Attach a

hose 12 mm to the drain and fix this with a hose clamp. Proceed cautiously in order

not to burst the drain from the condensate tub.

Guide the hose with slope of the device into the drain away (at least 5 cm slope per

meters).

If the dryer is placed on a wall bracket or otherwise increased, the drain hose can

be led by the opening in the balance downward.

ATTENTION:

Make sure that the condensate can always be handled safely.

6.6 Condensate pump (optional extra)

Optionally for AD 420 / 430 a pump-out-kit is deliverable. You receive the "pump-

out-kit" from your AERIAL-dealer.

The pump out kit can be installed with few handles completely simply and removed

again when desired.

Pump-out-Kit for AD 420 / 430

(a) hose connector

for hose 12 x 2 mm

page 10 of 16

(b) Twist-off for the

adjustment of the

pump-out-kit in the

bucket area.

Turn for removing =

turn twist-off left, in

horizontal position.

Turn for fixing =

Turn twist-off right, in

vertical position

pump out (before

moving the unit)