displayit Flare 조립 지침 매뉴얼 - 페이지 4

{카테고리_이름} displayit Flare에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. displayit Flare 6 페이지. 20' (230” x 92”)

Center Channel

7. Attach the bottom of the curtain light to the center

channel of the frame using light clips (Diagram 3).

To attach clips, hook each clip through the wire loop.

Squeeze clip, insert into channel, and release.

Suggested light clip locations are marked on the ruler.

Carefully unroll the curtain light and clip the top clips

into the top of the frame, keeping the wires straight.

9. Run each main power cable through the wire

pass-throughs. Connect all power supplies to the cords

starting with the transformers in the middle of the display.

Four transformers will connect to each power cable.

Plug the cables into an AC outlet to test the lights.

11. With at least two people, carefully stand the display

up. Inspect the connections between frame pieces. If

any gaps occured when smoving the frame, loosen the

wing-nuts, press the frame back together, and retighten

the wingnuts.

displayit.com

8. Attach the power supplies to the frame via the velcro

strips and connect the wires to the curtain lights.

Counterbored holes

11. Attach feet using t-bolts and wing nuts.

Each t-bolt goes through a counterbored hole in the foot, then

through a hole in the metal frame.

For the corner feet, each t-bolt then passes through the corner

bracket. Secure each t-bolt with a washer wing nut.

Hand-tighten until snug; do not over-tighten.

12. To help stop wire shadows on the graphic, use the

provided snap-on wire management clips. The curtain light

clips may also be used for wire management.

800.207.0311

After-Hours Emergency: Call or Text 678.723.5343

20' (230" x 92") Flare

Assembly Instructions Page 4

Flare v3.2 Updated 9/4/2019