3D Systems ProJet 4500 포스트 프로세싱 매뉴얼 - 페이지 10
{카테고리_이름} 3D Systems ProJet 4500에 대한 포스트 프로세싱 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems ProJet 4500 13 페이지. 3d professional printer
3D Systems ProJet 4500에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (19 페이지)
페이지 인쇄
METHOD 2: SOY WAX DIP
Pros
•
Best Color
•
Masks the odor of untreated part .
•
Will not dissolve small features .
•
Great for larger surfaces
•
Works for moving/interconnected parts .
1.
Place Ecosoya CB Advanced Soy Wax (enough to completely submerge a part, approximately 3.5lbs) in a container, in a finishing
oven at
50°C
(122°F). The wax comes in flakes, it will melt to approximately ½ its depth in liquid form (keep this in mind when filling the
container) . Melting wax will typically take
To speed the melting process you may increase the heat of the oven, and then cool the wax back down until it reaches
to not melt your container; it is recommended not to exceed
NOTE: If a different wax is used, be sure that the wax has a melting point ≤50°C .
Set Oven Temperature, place wax in Sterilite tub, use thermometer to check wax temperature
2 .
With the oven at
50°C
place the part in the oven to warm up for
3D Systems, Inc.
4-8
hours; wax should be melted before it is needed or maintain a liquid state to avoid a delay .
70°C
10-15
Preheat part in the oven for 10-15 minutes before waxing .
10
Cons
•
Lengthy
•
Wax may congeal in tight spaces .
(158°F) . Place a cooking thermometer in the wax to ensure it is 50°C .
minutes .
50°C .
Be careful