3D Systems ProJet 4500 포스트 프로세싱 매뉴얼 - 페이지 12

{카테고리_이름} 3D Systems ProJet 4500에 대한 포스트 프로세싱 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems ProJet 4500 13 페이지. 3d professional printer
3D Systems ProJet 4500에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (19 페이지)

페이지 인쇄

5 .

There may be drops of liquid wax clinging to the bottom surfaces of the part . Dab these off with a paper towel . If any undesired visible

wax remains on the part use the paper towel to get as much off . If a paper towel doesn't work use a scraper (for large surfaces) or a

pic (for tight areas) to remove the extra wax . If more than a paper towel is used, you may want to place the part back in the oven for

approximately 5-10 min to allow the wax smooth out along the surface .

Remove any leftover wax . Place the part back in oven for 5-10 minutes .

Left – Standard cleaning; Middle – IPA dipped; Right – Wax Dipped

3D Systems, Inc.