Aerial Airborne Wakeboard Tower 설치 매뉴얼 - 페이지 13

{카테고리_이름} Aerial Airborne Wakeboard Tower에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aerial Airborne Wakeboard Tower 14 페이지.

STEP 14 - LOCKING ThE ROTATING FITTINGS

STEP 15

Lowering the Tower.

loosen the rear tower hinges about 1/4 turn. the front tower hinges need to be disconnected

with the help of an Allen key to allow the tower to fold back.

once the tower is folded back, remove the 2 Allen bolts from the top section hinge which will

allow the arms to fold down for storage.

once you are happy with your tower installation and all

of the fittings are lined up to allow the tower to fold and

function correctly it will then be important to firmly lock the

rotating fittings in place to prevent any unwanted rota-

tion or loosening. to do this the m12 x 40mm bolts that run

through the center of the fittings will need to be firmly tight-

ened. next, the pre-instaleld m6 x 10mm fasteners found

in the fittings will then need to be firmly tightened with an

Allen key. we recommend using threadlocker during this

step.

m6 x 12mm

GUIDE#: pwb-AIrbornE-v1-004