Aerial Ascent 2.0 설치 매뉴얼 - 페이지 4

{카테고리_이름} Aerial Ascent 2.0에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aerial Ascent 2.0 7 페이지.

steP 1
steP 2
steP 3
4
With masking tape, cover the area where the mounting brackets
will be placed. This should be done at all points where the tower
will make contact with the deck as well as the surrounding area.
This will help to eliminate scratches to your boat while adjusting and
measuring your tower attachment points.
With your tape measure, measure the distance across the beam of
your boat where the rear mounts will be fixed and write down the
measurement numbers.
Next, measure up from the rear mounts to the front mounting loca-
tions and mark a general location on the masking tape where the
mount will sit.
connect the 2 rear vertical bent tower bars to the top cross bar.
now position the feet the same distance as the measurement you
have from the rear mount beam distance.
Note: Both SIDE and TOP mounts are possible. For a side mount, be
sure to add 1 1/2" to both sides of your tower bar width so a total of
3 additional inches. This is to compensate for the mounting feet.
GUIDE#: BT-ascEnT-001