Aerial Assault Wakeboard Tower 설치 매뉴얼 - 페이지 13

{카테고리_이름} Aerial Assault Wakeboard Tower에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aerial Assault Wakeboard Tower 13 페이지.

STEP 20 - LOWERING ThE TOWER

STEP 21 - INSTALLING ThE NAVIGATION LIGhT

nAVIGATIon LIGhT

(SHIppeD SepArATeLY)

Lowering the tower requires at least 2 people.

Never trailer your boat with the tower in the lowered position.

Always check to make sure all fasteners are tight and secure before

using the tower again.

opTIon A

DISconnEcT

The navigation light is shipped separately.

It is designed to be installed on the top of the tow point.

For a clean wiring installation the wires supplied can be passed

through the center of the tow point, along the inside of the top-sec-

tion and down inside the front leg tube. The wires will need to exit the

front leg tube just above the fittings and then be passed over the fit-

tings before entering back into the side rail front tube. Finally the wires

will exit the side rail front tube just above the mounting foot and then

enter the deck of the boat (through a hole that will need to be drilled)

so that they can be connected to a switch and power source.

Note: The tower is not supplied with pre-drilled wiring holes as each

customer may have a different wiring requirement depending on how

they fold their tower or the accessories that they will mount to the

tower.

Questions?

LooSEn

www.aerialwakeboarding.com

opTIon b

DISconnEcT

LooSEn

GUIDE#: pwb-ASSAULT-004