Aerial HF2 Series 사용 설명서 - 페이지 6

{카테고리_이름} Aerial HF2 Series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Aerial HF2 Series 17 페이지. Hepa filter

In this box you find tips and information concerning the use of

the device.

Designated use

The HEPA filter HF2 is designed for use with a side channel compressor or the

noise box VP2/VP3 as additional equipment for filtering mould spores and other

suspended solids in drying of the screed insulation layer using a vacuum

technique.

The HEPA filter HF2 is designed exclusively for use at atmospheric pressure.

Designated use also involves observing the specified operating conditions (refer

to page 6) and safety instructions (refer to page 4). Any use of the device going

beyond the designated use specified above is considered contrary to its

designated use.

Misuse is concerned if the HEPA filter HF2 is used for purposes not included in

designated use. In these cases the manufacturer does not assume any liability

for personal and material damage.

The HEPA filter HF2 was subjected to thorough safety testing. Improper

operation or misuse will cause danger to

the operator,



the device and other material property of the user,



efficient operation of the device.



All persons involved in the installation, commissioning, operation, maintenance

and servicing of the devices must

be properly qualified,



closely observe the instructions set out in this manual.



Air hoses and air filters must be properly installed. The operating elements must

always be accessible.

The HEPA air filter HF2 may only be operated by persons commissioned and

instructed by the user. In the working area the operator is responsible to third

parties. For all activities on the device the responsibilities must be clearly defined

and observed. Unclear competences are a safety risk.

SAFETY

Page 3 of 11