3D Systems LC-3D Print Box 빠른 시작 매뉴얼
{카테고리_이름} 3D Systems LC-3D Print Box에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Systems LC-3D Print Box 2 페이지.
페이지 인쇄
STOP: READ ME FIRST. DO THIS AT INSTALLATION.
The LC-3D Print Box-
The LC-3D Print Box comes with a pre-set voltage from the factory that may require changing to align
with your country specific voltage rating. Note: No damage will occur to your unit if plugged into a
different voltage than how the unit is configured. For proper heater and light output, it is required
to select the correct voltage. This is a one-time setting done at initial setup of your LC-3D Print Box.
Follow these instructions on how to change the pre-set voltage to your country specific voltage rating. Please
see the Voltage Rating Chart below to identify your country specific rating. Note: If your country is not list-
ed, choose the correct voltage from the pulldown list on the print box (see voltage list below).
Country
US
Germany
Italy
Spain
UK
Ukraine
France
Voltage selection on Printer Box
110V/115V
120V/127V
After print box is turned on, the pre-set voltage appears at lower right corner of welcome screen. It will also
display on the main screen in the upper right corner.
CHECK AND CHANGE YOUR VOLTAGE IF NEEDED
Voltage
Country
110V
Australia
230V
New Zealand
230V
S. Korea
230V
Canada
230V
China
230V
Mexico
230V
Chile
100V
220V
230V
240V
Country
Voltage
Czech Republic
230V
230V
220V
India
120V
Morocco
220V
Portugal
120V / 127V
Russia
220V
Taiwan
Turkey
Voltage
230V
230V
220V/127V
230V
220V/230V
110V
220V/230V