Distech Controls Allure ECL-600 Series 설치 매뉴얼 - 페이지 4
{카테고리_이름} Distech Controls Allure ECL-600 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Distech Controls Allure ECL-600 Series 17 페이지. Extension modules
Distech Controls Allure ECL-600 Series에 대해서도 마찬가지입니다: 설치 매뉴얼 (16 페이지)
페이지 인쇄
Mounting Instructions
The controller can be mounted on a DIN rail to speed up the installation procedure. They are also equipped with two mounting holes 0.25" x
0.165" (6.35mm x 4.191mm). The I/O Extension module can be mounted in a panel or on a wall by using appropriate screw types (use sheet metal,
thread forming, or self-tapping screws accordingly).
The controller's mounting orientation must be horizontal with controller's back attached to a vertical wall surface.
DIN Rail-Mounted Installation
1. Ensure the DIN rail is properly mounted on the wall.
2. Simply clip controller onto the DIN rail.
Wall-Mounted Installation
3. Open the enclosure by separating the front and back plate while pressing on the side clips.
4. Use the back plate's mounting holes to mark the location of any holes that need to be drilled.
5. Drill the holes.
6. Clean the surface and mount the controller using the appropriate screw types.
4 / 16
Figure 4:
Permitted Mounting Positions