Aerialix ARLX-OM2400-5 빌딩 매뉴얼 - 페이지 9

{카테고리_이름} Aerialix ARLX-OM2400-5에 대한 빌딩 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aerialix ARLX-OM2400-5 12 페이지. Collinear antenna kit

802.11 2.4Ghz Low-Power 5dBi Vertical Collinear Antenna

Figure 12. Radome construction materials.

In order to prevent the brass from "rattling" inside the radome, we suggest wrapping 1in/2.52cm of standard black electrical

tape to each coil as shown in Figure 13. When wrapping the coils with electrical tape, be sure to wrap it tight, as it will be

rubbing up against the interior of the radome during insertion. Loose fitting tape may cause jamming and subsequent bend of

brass elements. This should only be done if rattling is of concern.

Figure 13. Anti-rattling tape applied to the coils.

You will notice that one end of the radome has a larger inner diameter than the other end. Insert the top element of the antenna

into the milled end of the radome carefully. If you wrapped electrical tape over the coils, you may encounter resistance. If you

encounter a lot of resistance, remove the antenna and unwrap any coils that have an abundant about of tape on them. Do not

force the antenna assembly into the radome. Continue inserting the antenna assembly into the radome until the entire decoupler

and 0.50in/1.27cm of feedline, as seen in figure 14.