3D Upfitters AnkerMake M5 설치 매뉴얼 - 페이지 13

{카테고리_이름} 3D Upfitters AnkerMake M5에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3D Upfitters AnkerMake M5 18 페이지.

6. Install Vents

Before installing the front vents it would help if you placed the enclosure over the 3D

printer at this point.

The front fresh air vent is inserted from the outside and attached using M4 12mm

screws. This will bring cold air to the air intake vent of the case, cooling the electronics

inside. It's essential to keep the fan on the back panel running to help draw air through

the case's vents and outside when printing PLA and PETG.

Once you've secured the vents as shown above, place the lids on top. The lid ﬁts right

into the vent slots, helping to form a seal. Slide the 3D printer towards the front up

against the vent.