3dBanRC BanRC2 사용자 설명서 - 페이지 8

{카테고리_이름} 3dBanRC BanRC2에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3dBanRC BanRC2 16 페이지.

Glider should be in fly condition.

Do not glue the boom with fuselage till you check the balance of the model according to

weight "gm" of electronics you will use.

Steps:

1- Glue the Rudder Elevator with Boom.

2- Start with boom 700mm.

3- Insert the boom in fuselage.

4- Put the gilder on CG balance tool, if tail heavy, then shorten the boom by 100 "mm"

and check again, if tail still heavy, shorten boom by 50mm and check again. The

boom should be not less than 500mm

Boom

CG 75mm