CAME 9T90EN 설치 매뉴얼 - 페이지 4

{카테고리_이름} CAME 9T90EN에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAME 9T90EN 12 페이지. Control panel for 230 v - 400 v gearmotors

5 Installation

5.1 Preliminary checks

Before beginning to install, the following is necessary:

• Make sure that the point where the electrical panel is anchored is free from any impacts, and that the surface is solid and that

proper tools and materials are used (i.e. screws, wall plugs, etc.).

• Set up a suitable omni polar cut-off device, with distances greater than 3 mm between contacts, with sectioned power source.

•

Check that any connections inside the container (made for continuity purposes of the protective circuit) are fitted with extra

insulation compared to other internal conductive parts.

• Set up proper conduits and electric cable raceways, making sure these are protected from any mechanical damage.

5.2 Tools and equipment

Make sure you have all the tools and materials needed to carry

out the installation in total safety and in accordance with current

regulations. Here are some examples.

5.3 Fastening and mounting the container

1) Secure the base of the panel in a safe area; yes max. 6 mm

Head with to.

Assemble the pressure hinges.

5) Snap the cover onto the hinges.

2) Perforate the pre-punched holes and insert the cable glands

with corrugated tubes for the electrical cables to run through.

N.B.: the pre-punched holes have 20

mm diameter.

Careful not to damage the electronic

board inside the panel!

4) insert the hinges into the housing (either left or right) and secure

them using the issued screws and washers.

the slide to rotate

6) After adjusting and setting, secure the cover using the issued

screws.

15 mm ~