CAME Z Series 설치 매뉴얼 - 페이지 8

{카테고리_이름} CAME Z Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAME Z Series 11 페이지. Control board
CAME Z Series에 대해서도 마찬가지입니다: 매뉴얼 (8 페이지), 매뉴얼 (20 페이지), 매뉴얼 (4 페이지), 매뉴얼 (4 페이지), 매뉴얼 (17 페이지), 매뉴얼 (17 페이지), 매뉴얼 (13 페이지), 매뉴얼 (13 페이지), 매뉴얼 (16 페이지), 매뉴얼 (16 페이지), 매뉴얼 (12 페이지), 매뉴얼 (12 페이지), 매뉴얼 (18 페이지), 매뉴얼 (8 페이지), 매뉴얼 (20 페이지), 매뉴얼 (12 페이지), 매뉴얼 (12 페이지), 기술 문서 매뉴얼 (16 페이지), 사용 설명서 (16 페이지), 지침 (4 페이지), 빠른 매뉴얼 (2 페이지), 연결 매뉴얼 (4 페이지), 매뉴얼 (4 페이지), 매뉴얼 (12 페이지), 매뉴얼 (20 페이지), 매뉴얼 (15 페이지), 사용 설명서 (12 페이지), 빠른 시작 매뉴얼 (12 페이지), 매뉴얼 (16 페이지)

5.6 Function selection

1 ON - Pre-ﬂ ashing upon opening and closing – Following an opening or closing command, the ﬂ ashing light connected on

E1-E2, ﬂ ashes for 5 seconds before the cycle begins.

2 ON - Automatic closing – the timer for the automatic closing is activated when the door completes its opening cycle. The set

time is adjustable, and it is any how conditioned by the possible intervention of the safety devices and dies not activate

after a total safety 'stop' or during a power outage.

N.B.: If «maintained action» mode is selected, check that the automatic closure function is disactivated (2 OFF).

3 ON - Detection of obstacle – When motor is not running (gate closed, open or after a total stop command), prevents any

movement if the safety devices (e.g. the photocells) detect an obstacle

4ON / 5OFF - open only' function with radio transmitter (with radio frequency card inserted).

5ON/ 4OFF - 'open-close-inversion' function with button (2-7) and radio transmitter (with radio frequency card inserted).

5.7 Adjustments

Trimmer TL. = regulates the motor working time, for each single opening or closing, it has a range of 2 to 60 seconds

Trimmer T.C.A. = Adjusts the waiting time in the opening position. Once this time frame has lapsed, an automatic closing pro-

cedure is performed. The waiting time may be adjusted to between 3 second and 60 seconds. Adjusting to the minimum excludes

the automatic closing function.

Trimmer T.R.2M. = Adjusts the waiting time closure delay for 2nd motor (3 to 10 seconds)

OFF