CAME ZA3P 설치 매뉴얼 - 페이지 11

{카테고리_이름} CAME ZA3P에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAME ZA3P 13 페이지. Control panel for 230vgearmotors
CAME ZA3P에 대해서도 마찬가지입니다: 설치 매뉴얼 (13 페이지)

ENABLING THE RADIO CONTROL

Antenna and AF radiofrequency card

Connect the RG58 antenna-cableto the corresponding

terminals.

Fit the radio-frequency card intothe slot on the control

board AFTER CUTTING OFF THE MAINS POWER SUPPLY.

N.B.: The control board recognizes the radiofrequency card

only when it is powered up.

Possible connection to a second operator that can

be activated from the second channel on the radio

Contact rated for: 5A-24 V DC

Memorization (max. 25 different transmitters)

CH1 = Channel for direct commands to a features of the gearmotor's control board

("open only / " open-close-invert" command or "open-stop-close-stop",

depending on the selection made on DIP-switches 2 and 3).

CH2 = Channel for direct command to an accessory device connected to B1-B2.

Keep the CH1 button pressed on the control board (the LED will ﬂ ash), send the

code by pressing the transmitter's

data has been saved.

Do the same with the CH2 button, and associated it to another of the transmitter's

buttons.

Totally cancelling the memory

Simultaneously keep pressed buttons CH1 and CH2 for over ﬁ ve seconds; when the LED stays lit, all of the radio control will

be cancelled.

circuit (N.O. contact).

button, the LED will stay on to conﬁ rm that the

FC1 FA2 FC2

2 C1 CX B1 B2

>5"

FA1

FC1 FA2 FC2

3 3P 4

2 C1 CX B1 B2