CAME BX-246 설치 매뉴얼 - 페이지 3

{카테고리_이름} CAME BX-246에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAME BX-246 13 페이지. Bx series

4.3 Description of parts

1 - Top cover

2 - Settings casing

3 - Control board support

4 - Endstop fins

5 - ZD2 electronic card

6 - Front cover to control panel

7 - Gearmotor release door

8 - Securing plate

9- Securing bolt

10- Securing screw plate

11- Nut

4.4 Dimensions

(mm)

Installation must be carried out by expert qualified personnel and in full compliance with current regulations.

Before installing, do the following:

• Make sure that the gate is stable, and that the castors are in good working order and properly greased.

• The ground rack must be well secured to the ground, entirely above the surface and free of any irregularities that may obstruct the

gate's movement.

• The upper guide rails must not create any friction.

• Make sure that there is a closing and an opening endstops.

• Make sure that the operator is attached to a solid surface and protected from any impacts;

• Make sure you have a suitable omnipolar cut-off device with contacts more than 3 mm apart, and independent (sectioned off) power

supply;

•

Check that any connections inside the container (that provide continuity to the safety circuit) are fitted with additional insulation

compared to other internal live parts;

• Make sure you have suitable tubing and conduits for the electrical cables to pass through and be protected against mechanical

damage.