3DGence DT3 매뉴얼 - 페이지 6

{카테고리_이름} 3DGence DT3에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DGence DT3 14 페이지.

Operation

1. Necessary supplies to operate

• Protective neoprene gloves, as well as protective

eye goggles, should be worn when cleaning parts

at the 3DGence DT3. Having a source of fresh

water nearby is helpful to wash off any solution

that splashes on exposed skin.

• Use stainless steel or plastic tongs to insert and

remove parts. DO NOT use aluminum tongs.

• VXL EX.

• Fresh water (ambient temperature).

2. Adding water to the tank

Verify the drain valve on the back of the unit (see

Figure 2) is closed, that the power cord is unplug-

ged, and that a drain line has been securely instal-

led as described in the Installation instructions,

step 3. Fill the tank until the water is one inch from

the top of the tank (approx. 2.7 liters). Try to antici-

pate the volume of parts being cleaned; adding too

many parts will cause the water level to overﬂow.

To solve the potential problem reduce the volume

of water initially being added.

Note that there is a level switch approximately

2.5cm below the top of the tank. The 3DGence DT3

will not operate if the water level drops below this

switch.

3DGence DT3

3. Powering up the system

Verify the power switch (see Figure 3) on the front

panel is off by depressing the right side of the

switch. As a normal industry safety practice, plug

the power cord into a 230vac ground fault interrupt

outlet. Turn the power switch on by pressing the

left side of the switch. The controller display will

light, and after a few seconds the controller will

display temperature and time. This is also where

the "home page" is located. To go to the "home

page" press the

key repeatedly until tempera-

ture and time are displayed.

Jet action cleaning