Acoustic Remedy RECTANGLE 소유자 매뉴얼 - 페이지 4

{카테고리_이름} Acoustic Remedy RECTANGLE에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acoustic Remedy RECTANGLE 8 페이지.

페이지 인쇄

C L I M A C A S E

Installation Instructions:

1. Open the box and remove the glass protection

foam first. Next, remove the side foam pieces to

make removal of the humidor easier. Make sure

the latches of the ClimaCase are snapped shut.

Stand the box up on end and grab onto the case

back just below the top foam end cap. Gently pull

forward and the top foam end cap should start to

come out of the box. Once the top end cap has

come completely out, grab it and toss aside. Next,

lift the ClimaCase out of the bottom end cap and

place glass side up on a padded surface.

2. Open the door and remove the box above the

String Swing. This box will include all components

in the Packing List.

3. While the door is open, familiarize yourself with

the five mounting holes - the center mounting hole

and the pair of holes on the top/bottom. Please

note: the holes at the top/bottom are spaced 16"

apart to allow for securing into studs. If those

cannot go into the studs, the top mounting hole

needs to be screwed into a stud.

4. Re-latch the door before moving and locate a

suitable mounting location.

5. Using the stud finder, lightly mark the center of a

stud at desired location(s) with pencil and drill a

1/8" hole.

6. Insert 2" screw through the mounting hole with

~1/2" sticking through the back of the ClimaCase.

Line up the screw with the pre-drilled hole. Begin

advancing the screw slowly while putting slight

hand pressure on the back of the ClimaCase until it

becomes flush with the wall. Snug the screw tight,

taking care not to over tighten or strip out the

screw head.

A C O U S T I C R E M E D Y

O W N E R ' S

R E C T A N G L E

M A N U A L

7. Place the small level inside the bottom of the

ClimaCase and adjust as needed until it hangs

level. Mark the remaining mounting holes with a

pencil.

8.) Next, remove the first screw and set the

ClimaCase aside.

9. For the two mounting holes at the

top/bottom, use a 1/8" to pre-drill for stud

mounting or a 5/16" drill bit for toggle

installation. If using toggles, make sure the bit

fully penetrates the drywall at each mark and

insert plastic toggle by pinching each of the

"wings" of the toggle toward the center opposite

of the circular end and putting the pinched wing

portion partially into the hole. Tap flush with a

rubber mallet.

10. Repeat the process for the remaining

mounting point, ensuring the correct drill bit is

used for each mounting point.

11. Now that the holes are properly drilled,

reposition the ClimaCase and mount to the wall.

Take care to not over tighten or strip out the

screw head or toggle hole.

12. Insert the included wood plugs into all open

holes and tap gently with rubber mallet.