Acoustic Remedy RECTANGLE Руководство пользователя - Страница 4
Просмотреть онлайн или скачать pdf Руководство пользователя для Музыкальное оборудование Acoustic Remedy RECTANGLE. Acoustic Remedy RECTANGLE 8 страниц.
Печатать страницуC L I M A C A S E
Installation Instructions:
1. Open the box and remove the glass protection
foam first. Next, remove the side foam pieces to
make removal of the humidor easier. Make sure
the latches of the ClimaCase are snapped shut.
Stand the box up on end and grab onto the case
back just below the top foam end cap. Gently pull
forward and the top foam end cap should start to
come out of the box. Once the top end cap has
come completely out, grab it and toss aside. Next,
lift the ClimaCase out of the bottom end cap and
place glass side up on a padded surface.
2. Open the door and remove the box above the
String Swing. This box will include all components
in the Packing List.
3. While the door is open, familiarize yourself with
the five mounting holes - the center mounting hole
and the pair of holes on the top/bottom. Please
note: the holes at the top/bottom are spaced 16"
apart to allow for securing into studs. If those
cannot go into the studs, the top mounting hole
needs to be screwed into a stud.
4. Re-latch the door before moving and locate a
suitable mounting location.
5. Using the stud finder, lightly mark the center of a
stud at desired location(s) with pencil and drill a
1/8" hole.
6. Insert 2" screw through the mounting hole with
~1/2" sticking through the back of the ClimaCase.
Line up the screw with the pre-drilled hole. Begin
advancing the screw slowly while putting slight
hand pressure on the back of the ClimaCase until it
becomes flush with the wall. Snug the screw tight,
taking care not to over tighten or strip out the
screw head.
A C O U S T I C R E M E D Y
O W N E R ' S
|
R E C T A N G L E
M A N U A L
7. Place the small level inside the bottom of the
ClimaCase and adjust as needed until it hangs
level. Mark the remaining mounting holes with a
pencil.
8.) Next, remove the first screw and set the
ClimaCase aside.
9. For the two mounting holes at the
top/bottom, use a 1/8" to pre-drill for stud
mounting or a 5/16" drill bit for toggle
installation. If using toggles, make sure the bit
fully penetrates the drywall at each mark and
insert plastic toggle by pinching each of the
"wings" of the toggle toward the center opposite
of the circular end and putting the pinched wing
portion partially into the hole. Tap flush with a
rubber mallet.
10. Repeat the process for the remaining
mounting point, ensuring the correct drill bit is
used for each mounting point.
11. Now that the holes are properly drilled,
reposition the ClimaCase and mount to the wall.
Take care to not over tighten or strip out the
screw head or toggle hole.
12. Insert the included wood plugs into all open
holes and tap gently with rubber mallet.