Aeritech ISO 조립 및 작동 지침 매뉴얼 - 페이지 12

{카테고리_이름} Aeritech ISO에 대한 조립 및 작동 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Aeritech ISO 12 페이지. Design for fpv

페이지 인쇄

Checking the power system

Power on the transmitter with the throttle stick and trim at the "OFF" position then power up the aircraft.

●



Hold the aircraft securely.



Remove any loose objects such as cloths, tools, etc from the area in front of the model.



Open the throttle (stick forward): the motor should now run and you should feel a strong air flow rushing out

from propeller. Please do not bench test the unit for more than 10 seconds as there is no flowing air to cool

the unit.



Move the throttle stick back to the "OFF" position.



Disconnect the battery from the electronic speed controller and then switch the transmitter off.

Test flying – Notes on flying the airplane.



For the first flight you should wait for a relatively calm day with no more than a gentle breeze.



A good flying site is a large, flat, open field; well away from trees, fences, high-tension overhead cables and

other potentially dangerous obstacles.



Carry out a complete check of the working systems.



All control surfaces respond correctly



Adequate throttle response and battery voltage



Perform a range check if haven't already



We recommend that you ask an experienced modeler to help you initially;



Switch the motor on, and launch the airplane strongly into the wind with the fuselage and wings leveled.



Allow the plane to fly straight and level initially; don't try to turn it when it is close to the ground.



Adjust the trims if necessary so that the model settles into a steady climb.



Check the model's response to control commands from the transmitter. You may need to increase or reduce

the control surface travels once the model is back on the ground.



Take the airplane up to a safe height and check its stalling speed.



Keep the speed well up on the landing approach to avoid stalling.



If you had to move the trims during the flight, correct the mechanical linkages before flying again. This allows

you to re-centre the trims, so that full trim travel is available for subsequent flights.