Altman GALLERY SERIES 빠른 시작 매뉴얼 - 페이지 12
{카테고리_이름} Altman GALLERY SERIES에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Altman GALLERY SERIES 20 페이지.
페이지 인쇄Gallery Series
Canopy / Pendant Mount Models
IMPORTANT! Ceiling junction box and junction box screws are not included with Gallery Series
LED Luminaires and are by others.
WARNING! Canopy / pendant mount models must be installed by qualified professional installer
and should be done in accordance with local and national codes.
WARNING! Make sure power to the junction box is completely disconnected. Failure to do so
could lead to serious injury or death.
To wire and install canopy / pendant mounted models:
Step 1. Install Gallery Series LED Luminaires Mounting Flange to ceiling junction box. Ceiling junction box
is octagon-style box (by others). Mounting hole spacing is 3.5-inches (88.9 mm).
Step 2. Connect wiring to fixture. Refer to
(Sink Current)"
Step 3. Align fixture bottom mounting flange with top mounting flange screws.
Step 4. Turn clockwise securing the unit to top mounting flange.
Step 5. Tighten flange screws.
Page 12
"Connecting Power" on page 8
on page 14 as applicable
Top Mounting Flange
(Mounts to Junction Box)
Flange Screw (x2)
Figure 11: Canopy / Pendant Mount
or
"0-10V Controlled Models
3.5IN / 88.9 MM
Bottom Mounting Flange
Quick Start Guide