3DLab GANG PRINT BEAT PZL p.11c 사용자 설명서 - 페이지 18

{카테고리_이름} 3DLab GANG PRINT BEAT PZL p.11c에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DLab GANG PRINT BEAT PZL p.11c 19 페이지. Polish fighter

member of Group

WING ASSEMBLY

Right Wing Assembly: start by connecting the middle part (7) with the ﬁrst wing part (18), then prepare the

parts 19-20.

Note: Before connecting the part (20) install the servo and run the servo cable through the prepared hole.

Aileron: Glue together the parts with the installed servo (19-20-21) into which you put the inner part of the

aileron (25) ﬁtted with a 0.9mm-1.2mm axle made from a bowden wire or paper clips, then install the outer part

of the aileron (26) with the axle from each side and connect both parts of the ailerons so that the axle ﬁts into

the wing openings.

Warning: Apply the glue carefully so that the aileron remains movable.

Right Wing Assembly Completion: Put on the part number (22) onto the aileron axle and glue part (22) with

the the wing part (21). The completed wing assembly cement to part number (13), then to the assembled wing

attach the strut mounts (29-30). Then attach wing struts (35) for ﬁxing the wing to the fuselage.