Camec 043993 설치 및 운영 지침 매뉴얼 - 페이지 3
{카테고리_이름} Camec 043993에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Camec 043993 11 페이지. Instantaneous gas water heater

coach. Do not install the water heater or any other appliance where it can vent into an area
covered by an awning, canopy or any other enclosure. For better support and ease of
installation, install where the bottom of the heater case rests on a floor.
Installing Heater In The Side Wall Of An RV
The model IWH-1.5 refers to the heater with a surface mount door. The IWH-1.5 can retrofit
most tank water heaters without side wall modification regardless of side wall framing. It is
possible, that you have to use a kind of adapter frame.
Surface Mount Installation
Surround the opening on the skin of the coach with four to six inches of masking tape to pro-
tect the skin of the side wall.
Cut a rectangular hole with a width of 33 cm and a height of 33cm at the selected position.
Push the IWH-1.5 into the opening. Center the heater in the opening and start a screw in the
top center hole.
Run the screw down but not tight. Apply silicone or other appropriate sealant under the IWH-
1.5 flanges.
Push the unit into the opening to bed into the sealant. Now screw in the other three center
screws.
Apply silicone or other appropriate sealant heavily in the corners and on the flange around
the corner holes.
Place the corner pieces in the corner so the holes line up and put four screws in each corner.
Seal where the corner bracket meets the corner of the case. Remove excess sealant.
3