Camec 043993 설치 및 운영 지침 매뉴얼 - 페이지 4

{카테고리_이름} Camec 043993에 대한 설치 및 운영 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Camec 043993 11 페이지. Instantaneous gas water heater

Connection of the Gas Supply

Connect an approved gas line at the 3/8" (or ½") standard gas inlet and use an approved

sealant for this connection. Due to the high gas rate we recommend a gas supply pipe of

8mm minimum diameter. Gas pipe sizing and flueing must be in accordance with AS 5601.2

The cold water inlet and the hot water outlet are connected via 2 standard ½" male fitting.

Use a rubber seal or other removable sealants.

Piping and components connected to the heater shall be suitable for use with potable

water. When tightening water connections to the water line, be sure to back up the fittings with

a wrench as to not damage the copper water tubing. Re-tighten the compressions nuts on the

water fittings. With the power and gas supply to the heater turned off, pressurize the water system,

purge it of all air and check for leaks.

The water heater is controlled and started by the water flow. If the water flow is higher than

2.5 l/min, the burner starts automatically and heats up the water to the desired temperature.