aerl EarthGuard EG-300 설치 및 운영 매뉴얼 - 페이지 7

{카테고리_이름} aerl EarthGuard EG-300에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. aerl EarthGuard EG-300 15 페이지. Earth leakage detection

Introduction

Thanks for supporting local manufacturing with your purchase of an Australian designed and made

product.

Utilizing proprietary detection techniques, the AERL EarthGuard Insulation Monitoring Device

simultaneously monitors the unearthed PV Array (60 - 300V) and Battery Storage System (48/120V) for

conductor insulation degradation.

Installed on the battery bus, the EarthGuard monitoring device satisfies the earth fault detection

requirements of both AS/NZS 5033:2014 & AS/NZS 5139:2019 with onboard audio/visual alarms and an

alarm relay output for external fault indication.

Featuring support for full integration with AERL's CoolMax SRX charge controller range, EarthGuard can be

utilized in an integrated arrangement or as a standalone device for use with approved third-party

controllers, power conversion equipment and battery systems.

This installation and operation manual covers EarthGuard Firmware Revision v1.1.

All AERL products have been tested for compatibility with the EarthGuard EG-300 but some third-party

products may internally exceed the maximum allowed leakage tolerated by the EarthGuard, causing the

device to immediately trigger.

Please refer to the list below for supported third-party Controllers, PCE and Battery Inverters.

Selectronic SP Pro Series 1, 2 & 2i

Victron SmartSolar MPPT Series

Victron BlueSolar MPPT Series

Victron MultiPlus

Victron MultiPlus II & II GX

Victron Quattro Series

Products listed below are incompatible with EarthGuard and cannot be installed in systems requiring

compliance with AS/NZS 5033:2014 & AS/NZS 5139:2019.

Victron EasySolar II GX

AER013 REV 1.1

USER MANUAL

EarthGuard – EG-300

Australian Energy Research Labs

AER013 – Rev 1.1

21st July 2020