Balmar SG205 설치 및 운영 매뉴얼 - 페이지 8

{카테고리_이름} Balmar SG205에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Balmar SG205 19 페이지. Battery monitor

페이지 인쇄

EXAMPLE: If you are looking at a list of devices on the SmartLink network,

you can use short presses to move from one device to the next. When you

have the desired device highlighted, a long press will select the device,

and show the real-time data for that device. Similarly, if you are again back

at the list of devices, and use short presses to highlight "Setup", a single,

long press will take you to the setup menu for the selected device.

The extra-long press will reset the SmartLink network, which may be helpful

after software updates, in lieu of removing and replacing the fuse.

Bluetooth Gateway

The SG2-0300 Bluetooth gateway is a useful addition to the SmartLink net-

work. It can be used to both monitor and configure SmartLink devices through

an APP on both Apple and Android smartphones and tablets.

The Gateway also allows for periodic upgrading of devices, as new features or

improvements are rolled out.

NOTE: There are differences in the functionality available when using

the SmartShunt with the color display, or directly to the Balmar APP.

NOTE: When using the APP to upgrade SmartLink devices, always start

with upgrading the Bluetooth Gateway itself, if it has an upgrade available.

You see the changes in the latest upgrades, as well all previous versions here:

http://www.balmar.net/sg200-upgrades/

Google Play Store

Search "Balmar"

Apple App Store

Search "Balmar"

Real-Time Data

Once a SmartShunt is selected, the SG200 will display the Real-Time

Data for that SmartShunt. Selecting a different SmartShunt will allow you

to view the data from that SmartShunt and battery-bank. You will see the

SmartShunt bank selected on the top bar of the SG200 screen.

Real-Time Data parameters

Parameter

Unit

Voltage

Volts (V)

State of

Percent (%)

Charge (SoC)

State of Health

Percent (%)

(SoH)

Current

Amps (A)

Time

Hours: Minutes

Remaining

Voltages for

Volts (V)

two separate

Auxiliary

batteries

NOTE: If left on any MENU screen, the Display

will revert to Real-Time Data after a time.

Note

Voltage of the Battery Bank

SoC is a percentage of the

actual full-charge capacity of

the battery, NOT the design

capacity Also, See the section

"Initial Accuracy"

SoH is the battery's existing, or

actual aged capacity compared

to the initial design capacity.

Shows the NET of

simultaneous charge, minus

any discharge.

Shows time remaining until

battery is 50% (20% for

LiFePO

) discharged when the

battery is discharging. When

charging, shows the time until

charge completion. .

Typical usage would be the

starter battery for one or two

engines, or a single engine and

generator.