Balmar 97EHD Series 설치 및 운영 매뉴얼 - 페이지 12

{카테고리_이름} Balmar 97EHD Series에 대한 설치 및 운영 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Balmar 97EHD Series 20 페이지. Alternator

Single-foot and Vortec mount versions Isolated Ground:

Positive Output Terminal - Must be connected via properly-sized

cable to the battery or batteries being charged. Cable size is determined by

alternator output and length of cable run. See Page 3 for wiring size chart.

2. Stator Output Wire (WHITE) - Provides an unrectified source of AC voltage

which can be used as a signal for an electric tachometer.

3. External Field Wire (BLUE) - Connects to external voltage regulator via

wiring harness.

4. Internal Regulator Excite Wire (BROWN) - Provides switched source

of voltage to the alternator's internal regulator. Only connected when the

internal regulator is being used.

5. Internal Regulator Voltage Sense Wire (RED) - Provides sensing voltage

when the internal regulator is used.

6. Negative Terminal (Ground) - Must be connected to system ground via

properly sized cable. Cable size is determined by alternator output and

length of cable run. See Page 3 for wiring size chart. Ensure that the ground

cable is adequately supported to supply strain relief. The wire exiting the

alternator and attached to this terminal MUST remain in place for the alter-

nator to function.

7. Temp Sensor - Install the ring terminal end of the (Optional) MC-TS-A here.

Do not bend the heat shrink or ring terminal.

CAUTION: Positive Output and Negative (Ground) cable must be properly

supported to ensure that terminal posts are protected from excessive

weight and torque. Failure to provide adequate strain relief could result in

damage to the alternator and cables.

NOTES

Page

XT-SF-170-IG-XX shown. Wiring is

the same for Vortec model XT-VT-170-

IG-XX