3DR Quad DIY Kit 사용 설명서 - 페이지 2
{카테고리_이름} 3DR Quad DIY Kit에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DR Quad DIY Kit 8 페이지.
페이지 인쇄C O NT E NTS
30 mm threaded spacers (4)
18 mm threaded spacers (12)
8 mm threaded spacers (4)
5 mm steel bolts (24)
5 mm nylon bolts (8)
Metal lock washers (8)
Metal nuts (16)
Nylon nuts (4)
Rubber washers (4)
Zip ties (8)
Battery strap
Heat shrink tubing
Deans connectors - male (4)
Five-wire RC receiver cable
Two-wire RC receiver cable
You will also need:
» Phillips screwdriver (small)
» 5.5 mm (7/32) wrench
» Double-sided foam mounting tape
30 mm steel bolts (4)
25 mm steel bolts (12)
850 Kv motors with
bullet connectors (4)
Option: 880 Kv motors
XT60 connector -
male
10 x 4.7 SFP (pusher) propellers (2)
Option: 11 x 4.7 SFP propellers
10 x 4.7 SF (normal) propellers (2)
Option: 11 x 4.7 SF propellers
» 2 mm (5/64) hex wrench
» Soldering equipment
» Blue threadlocking compound
Your 3DR Quad Kit contains:
Bottom plate
APM plate
Electronic speed
controllers (4)
Black arm (3)
Blue arm (2)
Top plate
Landing gear
Accessory
pieces (8)
plate
Power distribution board
Power module with Deans or
XT60 connectors
6-position power
module cable
Deans to XT60 adapter
These instructions require some minor
soldering. If you're unfamiliar with
soldering, our friends at Sparkfun have
some great tutorials that can get you
started, including this comic:
learn.sparkfun.com/curriculum/42.
For an example of exactly what you'll
be doing for this assembly (soldering
Deans connectors to ESCs), check out
this video: youtu.be/3LJIQeKuLLU.
1