3DR Quad DIY Kit 사용 설명서 - 페이지 4
{카테고리_이름} 3DR Quad DIY Kit에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DR Quad DIY Kit 8 페이지.
페이지 인쇄3
Install motor collets
Attach a threaded collet to the top of each motor using the
four small screws included with collets. Apply threadlock to
each screw before fastening. Repeat for all four motors.
4
Assemble legs
Metal nuts
25 mm bolts
Leg assembly
5
Attach top and bottom plates
The top and bottom plates will form the main frame by attaching to your copter's arms.
Align plates in the orientation show below, and attach two blue arms to one end and two
black arms to the other using the four pairs of holes as shown.
Bottom plate
Attach black arms here
Attach blue arms here
Next add the spacers that will hold the power distribution board in place.
Using the four holes in the bottom plate shown across, align four 8 mm
threaded spacers, and secure from the bottom using four 5 mm nylon
bolts.
Slide the battery strap through the two slots in the bottom plate.
5 mm
nylon
bolts
18 mm
spacers
Place the arm between the two plates so the two holes
in the arm align with the holes in the plates. Insert a bolt
Top plate
into each hole and secure with nuts. For inner holes use
30 mm bolts and metal nuts; for outer holes use 25 mm
bolts and metal nuts. Add a rubber washer on top of the
nut on the inner holes.
For plus configuration: Attach a blue arm to only the
position on the plate marked with an arrow.
Inner holes use:
30 mm bolt + arm + metal nut + rubber washer
Outer holes use:
25 mm bolt + arm + metal nut
Your Quad has four legs, each comprised of two
landing gear pieces. To assemble each leg, align
two landing gear pieces and attach through the
three bottom holes using three 18 mm threaded
spacers and six 5 mm nylon bolts.
For each hole, position spacer between holes,
and secure from each side with nylon bolts.
Repeat for all four legs.
Attach legs to arms with leg pointing toward
motors. Align the two top holes in the leg with
the two holes in the center of the arm. Insert
two 25 mm bolts and secure with metal nuts.
5 mm nylon bolt + 8 mm spacer
Motor collet assembly
Bottom plate
3