Balt 27508 조립 지침 매뉴얼 - 페이지 4
{카테고리_이름} Balt 27508에 대한 조립 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Balt 27508 7 페이지. Floor lectern
페이지 인쇄
Do not use unless all screws are tight. At least every six months, check all screws
to be sure they are tight. If parts are missing, broken, damaged, or worn, stop use
of the product until repairs are made by your dealer using factory authorized parts.
Place the Back Panel (P-4) with the
8.
Pre-drilled holes facing up and install 6
each Cam Locks (C) in the 6 large holes
as shown in illustration # 3.
Attach Right Metal Bracket
9.
(P-7R) to Back Panel (P-4) using
2 Screws (A1) as shown
in illustration # 3.
C
Illustration # 4
H
J
Illustration # 5
H
J
P-4
C
P-9
C
P-3
Illustration # 3
C
Be sure that arrow on
top of Camlock (C)
aligns with centerline of
Edge Drilled hole.
Centerline of
Edge Drilled
hole.
Place the Middle Shelf (P-9) with the
10.
Pre-drilled holes facing up and install 4
each Cam Locks (C) in the 4 large holes as
shown in illustration # 4.
11.
Insert 1 Grommet Sleeve (H) in Round
opening in Middle Shelf (P-9) as shown in
illustration #4.
12.
Snap Grommet Cap (J) into Grommet
Sleeve (H) as shown in illustration #4.
13.
Locate Bottom Shelf (P-3) and Insert 1
Grommet Sleeve (H) in round opening as
shown in illustration #5.
14.
Snap Grommet Cap (J) into Grommet
Sleeve (H) .
4
P-7R
A1
Phillips
Screwdriver
Arrow
P-1