Acoustic Research PW1000 빠른 시작 매뉴얼 - 페이지 5

{카테고리_이름} Acoustic Research PW1000에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Acoustic Research PW1000 6 페이지. Home theater power station with speed pass

페이지 인쇄

The PW1000 uses AR PureCurrent™ power conditioning to clean the power that goes to

Power /

your home theater components and portable devices. It also protects these devices and

Charging /

components from harmful surges. Its 10 AC outlets are split into two types: 4 Always-On

Signal

Protection

outlets for components you want to keep powered all the time, and 6 Switched outlets you

SETUP

Back Panel

1. Plug the PW1000 into a grounded outlet.

IMPORTANT: DO NOT plug into a 2-prong outlet or use a ground lifter. The POWER and

PROTECTED indicators should be on when you plug in the PW1000. If they aren't see the

User Manual for troubleshooting tips.

2. Plug in the Always-On outlets. These outlets will be powered when the PW1000 is

plugged in and functioning.

3. Plug in the Switched outlets. These outlets will be switched on and off by the switch

on the front panel.

4. Plug the coaxial cables carrying your satellite, cable, and/or antenna signal into a

SAT/CABLE IN jack. Use a coaxial cable (not included) to connect the corresponding

OUT jack to the signal input on your receiver or TV.

4. Plug in the PW1000 and turn it on.

The POWER light in the ETHERNET section on the front panel of the PW1000 turns on and stays on.

The PORT indicators on the PW1000 front panel turn solid blue for each PORT where there is a device

connected. These indicators blink when data is being transmitted to or from that device.

Front Panel

The front of the PW1000

offers 2 always-on

AC outlets and 2 USB

charging ports. These

outlets and ports work

whenever the PW1000 is operational.

USB CHARGING outlets support a wide range of USB-

powered portable devices. The top outlet is optimized for

devices that require extra current, such as tablets. This

outlet can supply up to 2.1 Amps of charging current.

Before using the

2.1 Amp USB outlet,

make sure you have

A: Optimized for iPad and other Apple

the switch above

products (except for iPod Classic and nano)

this outlet set to the

right position for your

device—you must

have it set BEFORE you

B: Works for most other devices

plug in your device. As

a rule of thumb, leave the 2.1 switch in B position unless

you have an Apple (A) or Samsung tablet (C) product.

C: Optimized for

Samsung tablets