Alto-Shaam 1000-MH2-1 설치, 운영 및 유지 관리 - 페이지 14

{카테고리_이름} Alto-Shaam 1000-MH2-1에 대한 설치, 운영 및 유지 관리을 온라인으로 검색하거나 PDF를 다운로드하세요. Alto-Shaam 1000-MH2-1 16 페이지.

페이지 인쇄

INTerIOr cLeANINg

Open the refrigerated cart door to warm the

interior of the cabinet.

1. Remove any loose food debris with a cleaning

cloth or small hand broom.

2. Use a mild, non-abrasive detergent and warm

water. Wipe-down the interior of the cabinet,

removing all food residue. This includes the

ceiling, floor, and walls.

Wipe-down the interior door panel and clean

the vinyl gaskets. Make certain to clean under

the gaskets to remove any mildew accumulation

or food residue.

3. Rinse all interior surfaces including the cabinet

door and gasket with clean water and a cloth.

Remove all rinse water.

4. Wipe interior surfaces with a clean cloth and

sanitizing solution for use on metal and vinyl

food contact surfaces. This is an important step

to control the build-up of unwanted mildew

and mold in the refrigeration system.

5. Allow interior to air dry with door open.

exTerIOr cLeANINg

1. Wipe all exterior surfaces

including the control panel,

door frame, latches, and hinges

with a damp cloth containing

a mild, non-abrasive, non-

chloride detergent solution.

2. Rinse detergent solution with a cloth and

warm water. Allow exterior to air dry.

3. Polish with any standard stainless steel polish

designed for use on food service equipment.

When cleaning the exterior of the cabinet,

always wipe with the grain of the stainless steel

to avoid scratching or marring the finish.

Do not USE ABrASIvE CLEAnIng

C omP o Un D S or Im P L E mE n t S .

d A N g E R

dIScoNNEcT UNIT FRoM

powER SoURcE BEFoRE

cLEANINg oR SERVIcINg.

c A r e A N d c L e A N I N g

M R 2 - 1 • M N - 3 6 2 4 6 ( R E V . 0 ) • I N S T A L L A T I O N / O P E R A T I O N / S E R V I C E M A N U A L • 1 2 .

T I T L e

gASkeT repLAcemeNT

Damaged gaskets can easily be replaced. Remove

the old gasket by gently pulling it out of the gasket

retainer and simply push in the new gasket leaving

the corners to last.

d A N g E R

AT NO TIME SHOULD THE INTERIOR

OR EXTERIOR BE STEAM CLEANED,

HOSED DOWN, OR FLOODED WITH

WATER OR LIQUID SOLUTION OF

ANY KIND. DO NOT USE WATER JET

TO CLEAN.

SEVERE dAMAgE oR

ELEcTRIcAL hAZARd

coULd RESULT.

WARRANTY BECOMES VOID IF

APPLIANCE IS FLOODED