Alto-Shaam 1000-MH2-1 Instalacja, obsługa i konserwacja - Strona 14
Przeglądaj online lub pobierz pdf Instalacja, obsługa i konserwacja dla Podgrzewacz do żywności Alto-Shaam 1000-MH2-1. Alto-Shaam 1000-MH2-1 16 stron.
Drukuj stronę
INTerIOr cLeANINg
Open the refrigerated cart door to warm the
interior of the cabinet.
1. Remove any loose food debris with a cleaning
cloth or small hand broom.
2. Use a mild, non-abrasive detergent and warm
water. Wipe-down the interior of the cabinet,
removing all food residue. This includes the
ceiling, floor, and walls.
Wipe-down the interior door panel and clean
the vinyl gaskets. Make certain to clean under
the gaskets to remove any mildew accumulation
or food residue.
3. Rinse all interior surfaces including the cabinet
door and gasket with clean water and a cloth.
Remove all rinse water.
4. Wipe interior surfaces with a clean cloth and
sanitizing solution for use on metal and vinyl
food contact surfaces. This is an important step
to control the build-up of unwanted mildew
and mold in the refrigeration system.
5. Allow interior to air dry with door open.
exTerIOr cLeANINg
1. Wipe all exterior surfaces
including the control panel,
door frame, latches, and hinges
with a damp cloth containing
a mild, non-abrasive, non-
chloride detergent solution.
2. Rinse detergent solution with a cloth and
warm water. Allow exterior to air dry.
3. Polish with any standard stainless steel polish
designed for use on food service equipment.
When cleaning the exterior of the cabinet,
always wipe with the grain of the stainless steel
to avoid scratching or marring the finish.
Do not USE ABrASIvE CLEAnIng
C omP o Un D S or Im P L E mE n t S .
d A N g E R
dIScoNNEcT UNIT FRoM
powER SoURcE BEFoRE
cLEANINg oR SERVIcINg.
c A r e A N d c L e A N I N g
M R 2 - 1 • M N - 3 6 2 4 6 ( R E V . 0 ) • I N S T A L L A T I O N / O P E R A T I O N / S E R V I C E M A N U A L • 1 2 .
T I T L e
gASkeT repLAcemeNT
Damaged gaskets can easily be replaced. Remove
the old gasket by gently pulling it out of the gasket
retainer and simply push in the new gasket leaving
the corners to last.
d A N g E R
AT NO TIME SHOULD THE INTERIOR
OR EXTERIOR BE STEAM CLEANED,
HOSED DOWN, OR FLOODED WITH
WATER OR LIQUID SOLUTION OF
ANY KIND. DO NOT USE WATER JET
TO CLEAN.
SEVERE dAMAgE oR
ELEcTRIcAL hAZARd
coULd RESULT.
WARRANTY BECOMES VOID IF
APPLIANCE IS FLOODED