3DUpFitters 3D Printer Carbon Air Filter 설치 매뉴얼 - 페이지 8

{카테고리_이름} 3DUpFitters 3D Printer Carbon Air Filter에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DUpFitters 3D Printer Carbon Air Filter 8 페이지. Carbon air filter/vent adapter

페이지 인쇄

The Prusa/Ender setup is a bit more complicated since window inserts are all 4", while the

hose we recommend is 3". This setup adds an 3"->4" hose adapter, and the 3" hose is small

and doesn't overwhelm the small enclosure. Note that with this setup you need 2 3" clamps

and 1 4" clamp.

To complete venting to the outside you can ﬁnd

online or at most hardware stores. This can be connected to the outside using the same

techniques you'd use for a clothes dryer, or you can purchase one of the many compatible

window-venting

kits. These items are not included and must be purchased separately. We

don't bother to stock them since they're readily available at local hardware stores.

The fan can either be plugged into a USB power supply (not included) or the wires stripped and

connected directly into some models of 3D printer.

ﬂexible 4" dryer duct hoses

ﬂexible 3" hoses