3DUpFitters Artillery Sidewinder X1 Enclosure Kit 설치 매뉴얼 - 페이지 6

{카테고리_이름} 3DUpFitters Artillery Sidewinder X1 Enclosure Kit에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DUpFitters Artillery Sidewinder X1 Enclosure Kit 13 페이지.

페이지 인쇄

Assemble Panels

The front panels are made from thicker 1/4" acrylic to provide more structural rigidity where its

needed: the door. Do not try to bend the 1/4" acrylic! The remaining panels are all 1/8".

In general use the 10mm cap head screws to attach things to the 3mm side panels, and

the longer 12mm cap head screws to attach things to the 6mm front.

1. The Front Panel 

Each of the corners on the enclosure will be held together by the connectors pictured

below. There are only two versions L and R, which can be identiﬁed by the letters

stamped on the inside. The opposite connectors are identical, i.e. Bottom Right is the

same as Top Left. In all cases the surface of the connector with the cutout pattern

faces front or back.

The front door is designed so that the latches are on the left. Attach the corner

connectors on the back side of the door frame using the provided cap head 12mm

screws. See the photos below. The top of the connector should be ﬂush with the top

of the acrylic.

Top Left

Bottom Left

Top Right

Bottom Right