Camille Bauer SINEAX V604s 사용 설명서 - 페이지 11
{카테고리_이름} Camille Bauer SINEAX V604s에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Camille Bauer SINEAX V604s 19 페이지. Universal signal converter
Camille Bauer SINEAX V604s에 대해서도 마찬가지입니다: 안전 지침 (13 페이지)
페이지 인쇄6.6 Confi guration parameters
Settings
Address
Description
Data type #
40515
DEVADDR
UINT16
40516
MODBUS
UINT16
Resetting of communication settings
Once the MODBUS settings have been stored in the device, communication with the device is only possible if the settings
are known.
The following technique resets the MODBUS settings to the delivery status:
- Device address: 01h
- Baudrate:
19200
- Parity:
None
- Stop bits:
2
A plug prepared for this purpose (Terminal + is connected to Terminal GND with a resistance of 1 kOhm) is connected to the
RS485 interface before the device is switched on.
After the device has been switched on, the red LED shines for approx. 30 seconds. During this time, the green LED fl ashes.
Subsequently, the red LED turns off (the green LED continues fl ashing). Within further 30 seconds, this plug has to be removed
from the device.
After the successful completion of this procedure, the communication default settings are stored again in the device.
If the procedure described is not adhered to, the interface parameters are not changed.
Camille Bauer
Default
Description
01h
MODBUS Slave address (1...247)
3222h
MODBUS settings
Bit
Description
0-2
Baudrate
0:
9600
1:
14400
2:
19200
3:
38400
4:
56000
5:
57600
6:
115200
7:
Reserved
3
0:
Odd parity
1:
Even parity
4
0:
Parity disabled
1:
Parity enabled
5
0:
1 Stop bit
1:
2 Stop bits
8-15
Response delay [ms] (5..255)
Operating instructions V604s Be
11