Camille Bauer SINEAX V604s 사용 설명서 - 페이지 3

{카테고리_이름} Camille Bauer SINEAX V604s에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Camille Bauer SINEAX V604s 19 페이지. Universal signal converter
Camille Bauer SINEAX V604s에 대해서도 마찬가지입니다: 안전 지침 (13 페이지)

페이지 인쇄

The existing COM ports are determined as the communi-

cation interface when starting the program and selecting

RS232/RS485. Only COM ports found are available for

selection.

Limiting the range of possible device addresses speeds

up the search of connected devices considerably.

Example: If only 2 devices are connected, it makes sense

to select the address range from 1 to 2.

All settings are stored as the program is terminated. If the

COM port is not available upon the next start of the pro-

gram (e.g. because the converter has not been plugged in)

another valid interface is set.

To determine which COM port has been allocated to

the RS485 converter (if required), please proceed as

follows:

3. Block diagram

3.7 kV

Inputs

Camille Bauer

Power supply

Operating instructions V604s Be

The COM port of an external RS232 or RS485 converter

may be determined (and, if required, changed) via the

Windows system control.

Example for Windows XP: System control => System

This example shows the COM ports of a PCMCIA card

and a USB-RS232 converter:

- Silicom Serial Card: COM1

- USB-RS232 adapter: COM4

If you use the Camille Bauer USB-RS485 converter

(Article Number 163189), the same is to be connected as

follows:

GND

3.7 kV

μP

USB

2.3 kV

Contact

A1+

Analog-

A–

outputs

A2+

0.5 kV

–

Bus

GND