esera automation ECO 208 PRO 사용자 설명서 - 페이지 12
{카테고리_이름} esera automation ECO 208 PRO에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. esera automation ECO 208 PRO 18 페이지. Professional 1-wire controller
페이지 인쇄
14.4
Web server, Interface Setting, Maxi Interface
Use the "Interface Setting" web page to set the basic settings for the Maxi interface.
In this menu, the operating mode of the Ethernet interface, TCP Server or UDP, of the ECO Controller is
configured.
The IP address, subnet mask and the gateway IP address are set here.
.
* if the sensor or actuator supports Auto-E-Connect. For details, please refer to the operating instructions of the sensor or actuator.
All rights reserved. Reproduction as well as electronic duplication of this user guide, complete or in part, requires the written consent of
ESERA GmbH. Errors and technical modification subject to change. ESERA GmbH 2021
www.esera.de
TCP Server or UDP operating mode
With this selection, the basic operating mode for the
ECO Controller Maxi Interface is set.
Port
The port address is assigned for socket 1, the
ESERA ASCII protocol.
The port can be selected in the range 1-50000.
The default port is 5000.
DHCP / Manual, Operating mode IP address
assignment
You can choose between automatic (DHCP) and
manual assignment of the IP address.
DHCP is activated in the delivery state.
IP Address
For automatic address assignment (DHCP), the IP
addresses are displayed.
For manual assignment of IP addresses, the
corresponding settings are entered in the fields
IP address, subnet mask and gateway.
Save / Back
Press the "Save" button to permanently save the
current settings.
If you do not want to make any changes, press the
"Back" button.
Click on the "LogOut" button to exit the web interface.
11603-48 V1.0 R1.1 Manual
Page 12 of 18