3DUpFitters Ender 5 Plus R1 Enclosure Kit 설치 매뉴얼 - 페이지 13

{카테고리_이름} 3DUpFitters Ender 5 Plus R1 Enclosure Kit에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DUpFitters Ender 5 Plus R1 Enclosure Kit 18 페이지.

7. Sealing Gaps

Once the enclosure is completely put together, it is time to make sure that each panel

is held tightly to each adjoining panel. The connectors are designed with a small

amount of play that allows you to make minor adjustments for the perfect ﬁt.

1. Loosen screws on the panel to move.

2. Push that panel into place. You may need a friend to hold it tightly in the right spot.

3. Re-tighten the screws to hold the panel. Only tighten enough to hold the pieces

snuggly. DO NOT OVER-TIGHTEN! These parts are sturdy, but they're still all made of

plastic.

Repeat the product, going around the enclosure, looking to make sure all of the panels

are ﬂush with each other.

8. Temperature Gauge

The optional thermometer will let you know

approximately what temperature it is inside

the enclosure. It attaches to the left side of

the door piece using the same hole as the

top-most corner connector, as shown. It

comes with a longer screw to ﬁt through

everything.