3DUpFitters Ender 5 Plus R1 Enclosure Kit Manuel d'installation - Page 13

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} 3DUpFitters Ender 5 Plus R1 Enclosure Kit. 3DUpFitters Ender 5 Plus R1 Enclosure Kit 18 pages.

Imprimer la page

7. Sealing Gaps

Once the enclosure is completely put together, it is time to make sure that each panel

is held tightly to each adjoining panel. The connectors are designed with a small

amount of play that allows you to make minor adjustments for the perfect ﬁt.

1. Loosen screws on the panel to move.

2. Push that panel into place. You may need a friend to hold it tightly in the right spot.

3. Re-tighten the screws to hold the panel. Only tighten enough to hold the pieces

snuggly. DO NOT OVER-TIGHTEN! These parts are sturdy, but they're still all made of

plastic.

Repeat the product, going around the enclosure, looking to make sure all of the panels

are ﬂush with each other.

8. Temperature Gauge

The optional thermometer will let you know

approximately what temperature it is inside

the enclosure. It attaches to the left side of

the door piece using the same hole as the

top-most corner connector, as shown. It

comes with a longer screw to ﬁt through

everything.