3DUpFitters Ender 5 Plus R1 Enclosure Kit Manuel d'installation - Page 12

Parcourez en ligne ou téléchargez le pdf Manuel d'installation pour {nom_de_la_catégorie} 3DUpFitters Ender 5 Plus R1 Enclosure Kit. 3DUpFitters Ender 5 Plus R1 Enclosure Kit 18 pages.

Imprimer la page

4. Top Panel

Use access through the doors to attach the top of

the enclosure using M4 12mm screws.

5. Right Panel

The right panel is a plain simple aﬀair by this

point. Just make sure to locate the bottom of the

panel, which is the only side without a hole.

6. Air Input Tray

There is an "air input tray" in front to get

enough air to the electronics. It consists of

two parts, the tray and a cover insert. Slide the

tray into the front of the enclosure, and then lay

the cover on top at the front as shown. There

are holes to use 12mm M4 screws to attach the

tray, but it's not needed in many cases. If you

do connect it, it must be unscrewed before you

can take oﬀ the enclosure.

Cover