3DUpFitters Ender 5 Plus R1 Enclosure Kit Посібник з монтажу - Сторінка 12
Переглянути онлайн або завантажити pdf Посібник з монтажу для 3D-принтери 3DUpFitters Ender 5 Plus R1 Enclosure Kit. 3DUpFitters Ender 5 Plus R1 Enclosure Kit 18 сторінок.
Друкувати сторінку4. Top Panel
Use access through the doors to attach the top of
the enclosure using M4 12mm screws.
5. Right Panel
The right panel is a plain simple affair by this
point. Just make sure to locate the bottom of the
panel, which is the only side without a hole.
6. Air Input Tray
There is an "air input tray" in front to get
enough air to the electronics. It consists of
two parts, the tray and a cover insert. Slide the
tray into the front of the enclosure, and then lay
the cover on top at the front as shown. There
are holes to use 12mm M4 screws to attach the
tray, but it's not needed in many cases. If you
do connect it, it must be unscrewed before you
can take off the enclosure.
Copyright 2021 3DUPfitters LLC
Cover
12