3DUpFitters FT-5 Enclosure Kit 설치 매뉴얼 - 페이지 13

{카테고리_이름} 3DUpFitters FT-5 Enclosure Kit에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DUpFitters FT-5 Enclosure Kit 16 페이지.

Right Side Panels

1. Right Top Panel

The right side top panel is similar to the one on the left, but without a ﬁlament slot, and

adding a cutout for the Y end-stop. Remember to install the rubber trim to avoid

rattling. Note the cutout on the bottom left, which is designed to ﬁt the R1 design. If

you have the newer design where this isn't needed, the corner brace will simply cover

it up.

2. Right Bottom Panel 

The right bottom panel is not identical to the left because of the location of the USB

access port. At this point there is only one panel left that is big enough.

3. Tight the t-nuts on the Braces 

Assembly of the back and right-side panels is now complete so any t-nuts that were

loosed during those steps can now to be rightened.

Top Panel

The one remaining panel is for the top. Attach the knob in the middle using an M5

screw. Then use the remaining hex screws and t-nuts to attach each of the corners,

making sure to only hand tighten the screws. Using a hand tool will cause the

acrylic to crack when heated! Use M5 8mm for acrylic and M5 10mm for wood.