3DUpFitters FT-5 Enclosure Kit 설치 매뉴얼 - 페이지 15

{카테고리_이름} 3DUpFitters FT-5 Enclosure Kit에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DUpFitters FT-5 Enclosure Kit 16 페이지.

Next, re-insert the screws to mount the extruder-side mounting as shown. The screw holes are

designed to be loose so that you can adjust the brass ﬁtting until it ﬁts exactly over the ﬁlament

feed position.

The next step is to attach the external PTFE mount. Its designed to go on the left side because

of the way the FT-5's carriage is oriented, but you can also ditch that part and make your own

top mounted ﬁlament holder. Attach to the top and middle rails as shown below using the

standard bolts and t-nuts. Some will be included, but you can also use any left over from

assembling the FT-5 kit.