3DUpFitters Prusa i3 MK2 설치 매뉴얼 - 페이지 10

{카테고리_이름} 3DUpFitters Prusa i3 MK2에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DUpFitters Prusa i3 MK2 11 페이지. Enclosure kit
3DUpFitters Prusa i3 MK2에 대해서도 마찬가지입니다: 설치 매뉴얼 (18 페이지)

페이지 인쇄

much tolerance in the placement of

the oﬀ/on switch and power cable

plug, so you'll have to get it pretty

close. This will make it easier to turn

oﬀ and on and provide the best seal

so that heat won't escape.

7. Spool Holder

Instructions for assembling the spool holder are available online. You can simply sit the

spool holder on the top of the enclosure where the ﬁlament can ﬁt into the slit. Of

course, you are free to use whatever type of freestanding spool holder you wish; there

are hundreds of designs available on Thingiverse.

8. Thermometer

The optional thermometer will let you know

approximately what temperature it is inside

the enclosure. It attaches to the left side of

the door piece using the same hole as the

top-most corner connector as shown. It

comes with a longer screw to ﬁt through

everything.