Division 6 Dual Mini Sequencer 사용 설명서 - 페이지 6

{카테고리_이름} Division 6 Dual Mini Sequencer에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Division 6 Dual Mini Sequencer 14 페이지.

Version 2

Instructions beyond this point refer to new features found in version 2 of the sequencer

firmware. You can tell if you have v2 by watching the sequencer's boot light show; after it lights

each row of LEDs sequentially, it will light the step 2 LED then the step 10 LED (for v2.0) before

the clock LED starts blinking. If it doesn't light any LEDs during this time then you have v1

firmware.

Song/Sequence selection mode

Press and release both the OCTAVE UP and OCTAVE DOWN buttons at the same time. This

changes the note key display to SONG/SEQUENCE SELECT mode. Pressing this button

combination again takes you back to the normal note select mode.

Selecting a Sequence

If the entire row of white keys is lit while displaying SONG/SEQUENCE SELECT, you are in

SEQUENCE mode. The selected sequence will play to the end then loop back to the beginning.

The sequencer has 7 sequence memories available for you to choose from. The steady LED

indicates the currently selected sequence. To select a different sequence, press the white note

key corresponding to the sequence you want to select. If the sequencer is running, the newly-

selected sequence LED will flash until the sequencer reaches the end of the current sequence

(or on the next clock; see CHANGE ON CLOCK mode), then it will switch to the new sequence.

Another way to select a sequence, even while the display is in another mode, is to hold down

the PROG/RESET button then press the desired sequence button. The display will automatically

change to SONG/SEQUENCE SELECT mode.