3DUpFitters CR-10 S4 설치 매뉴얼 - 페이지 13

{카테고리_이름} 3DUpFitters CR-10 S4에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DUpFitters CR-10 S4 15 페이지. Enclosure kit

The ﬁlament guide attaches to the Y motor (vertical

motion) by removing the two nuts, placing the

guide's holes over the two screws, and then

replacing the nuts.

The illustration to the right shows how the runout

sensor ﬁts between the guide and the extruder.