3DUpFitters CR-10 S4 설치 매뉴얼 - 페이지 14

{카테고리_이름} 3DUpFitters CR-10 S4에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. 3DUpFitters CR-10 S4 15 페이지. Enclosure kit

Bed Clips

In order to make the size of the enclosure as

small as possible, there may be little room on

the front of the bed for clips that stick out. If

you ﬁnd the enclosure needs a little more

room, attach the clips to the bed, and then

use needle-nose pliers to remove the clips.

Customizations

Spool Holder Location Changes

There are lots of reasons to customize your enclosure. Those of you who want to change how

ﬁlament is brought into the enclosure should feel free to drill holes as appropriate. With acrylic,

be very careful to tape the area ﬁrst on both the inside and outside, and use very little

pressure when drilling to gradually remove the plastic. If you do not follow these instructions

the plastic is liable to chip or crack the enclosure. Its not hard to do, but if you simply force the

bit into the plastic with no tape it will crack and chip.