Altocraft 68125136 운영자 매뉴얼 - 페이지 18
{카테고리_이름} Altocraft 68125136에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Altocraft 68125136 20 페이지. 18v cordless drill / driver
페이지 인쇄FUNCTIONAL DESCRIPTION
Fig.1
K
OPERATION
BATTERY PACK
IMPORTANT !
The battery is not fully charged. Before first use, the battery pack requires 5-7
hours charge time to be fully charged. Subsequent rec
hours for the battery to be fully charged.
Always switch to a fresh battery when tool performance begins to diminish.
Severe heat is most destructive to a battery; the more heat generated,
the faster the battery loses power. A battery that gets too hot can have a
shortened life.
Never over-discharge a battery by using the tool even after tool performance
has decreased. Do not attempt to discharge a tool's battery by continuing to
pull on the tool trigger. When tool performance begins to diminish, stop the
tool and recharge the battery for optimal performance.
Batteries will reach full performance after about five charge/discharge cycles.
1.
Always have drill rotation switch in neutral/lock position when removing or
2.
inserting battery to avoid unintentional starting.
To remove battery pack from the tool, press the lock spring buttons (J in the
3.
functional description) and pull out.
4.
To insert, simply push pack in until lock spring clicks.
5.
The battery charger consists of two parts:
1. a switching adapter/120 volt plug with a low-vo ltage lead
2. a charging stand
6.
To charge, connnect the switching adapter/plug low-voltage lead to the charging
stand.
18
CD302
C
A
D
G
E
J
L
Figure 1 names the major components of the CD302
cordless drill/driver:
M
3/8" (10 mm) chuck
A
B
Double-end driver bit
Torque regulation ring
C
F
D
Torque indicator scale
LED work light
E
H
Forward / reverse switch
F
G
Variable speed trigger with electric brake
Rubber-covered handle
H
I
18 volt lithium-ion rechargeable battery
Battery lock button
J
B
Charging stand
K
L
Switching adapter
Selector switch
M
I
harging needs 3-5
!